Locking Bimini Tube Hinge (w/ Push Button)

Locking bimini rail tube hinge with a quick release button for bimini tops and dodgers.  Allows bimini frames and tubing to break down and fold quickly, then click back into position.  Commonly used in situations where bimini has interference issues with wakeboard towers or other objects on a boat.  Made from high quality stainless steel.

• 180 degrees of hinging motion
• 316 Stainless construction
• For bimini frames, rails, dodgers, and other boat top framework
• Stainless set screws (can be replaced with rivets or thru-bolt screws for better fastening).  See below for more info.
• Fits 7/8″ outside diameter tubing

Hinge Hardware and installation options:

Option 1 (not recommended):  use small set screws (included) to secure hinges.  This is NOT the preferred method as it allows hinge to slip and easily loosens.

Option 2 (good):  Aluminum Rivets.  This provides a decent hold and the aluminum rivets are easy to install compared to the stainless rivets.  3/16″ stubby drill bit included for installation.

Option 3 (better):  Stainless Steel Rivets.  These provide better holding power than the aluminum rivets, but are more difficult to install if using regular duty rivet hand tool.  3/16″ stubby drill bit included for installation.

Option 4 (best):  1/4-28 x 1” Stainless Steel Button Screws.  The screw goes through the center of the tubing and pinches on the backside.  This is a great way to install hinges and also allows easy removal for servicing or replacement.  Using a small amount of grease or anti-seize lubricant is suggested to prevent galling (bind up). 19/64″ stubby drill bit included for installation.